There should be a series of screws that connect that portion of the lock to your door.

Uninstall door lock. Unscrew and remove the two screws from the door lock. Grasp the interior trim in one hand and the exterior trim in the other and try to pull them away from the door. Once your latch plate is off and your casing bolts are removed pull the 2 halves of the lock straight out on each side of the door. Push button and remove knob.

Now that you ve located the slot you ll need a flat head screwdriver or a small. Once you remove the screws the lock should become loose and you can pull both sides of the lock out of the door. You ll see the frame of the lock that holds the latch or dead bolt plug remaining in the hole. This is what holds the knob in place.

This is showing how you can get your lock apart when you don t see any screws. Find the screws on the side of the door that secure the latch plate. Remove the latch mechanism if you re installing a new handle. Use the flat head screwdriver to turn the spindle in the center of the door lock cylinder counterclockwise until it.

Apply a bit of pressure to the paper clip to trigger a release button inside the hardware. Remove this screw using a drill or screwdriver. How to remove cylinder door locks 1. Once triggered the lever or lock trim can be removed from the door.

If any screws are exposed during this process remove them to release the lock and remove it from the door. Often this set screw is the only thing holding the two halves of the lock in place. This was a keyed door lever lock but i mention how to do the same with the sta. When you remove the faceplate it will reveal the inside of your knobset lock.

Take out the screws then carefully pry off the plate with a flat head screwdriver. Look for a small set screw at the base of the handle. Remove the screws in the knob with a screwdriver. All knob locks have what s known as a slot with a latch.

These screws are usually phillips head screws and hold the two.

• Décorations De Ballons à Air Chaud Vintage